2007 Audi RS4 Speaker Sizes
The 2007 Audi RS4 speaker size chart provides factory specifications for replacement or aftermarket audio system components. Information includes speaker locations in front door panels and rear door panels. Details cover factory audio specifications to assist with upgrade or replacement of audio system components with compatible aftermarket speakers.
As an Amazon Associate, we may earn a commission from purchases made through links marked. Read more in our disclaimer.
| Location | Size | Type | Notes |
|---|---|---|---|
| Front Door Panel | 6.5 | Midbass / Full-Range |
|
| Rear Door Panel | 6.5 | Midbass / Full-Range |
|
2007 Audi RS4 Speaker Replacement Summary
2
total positions
2
easy to replace
1
high priority
0
professional only
Replacement difficulty:
Low: 2 Medium: 0 High: 0Replacement priority:
High: 1 Medium: 1 Low: 02007 Audi RS4 Radio Slot Size (DIN)
| DIN Type | Size (inch) | Size (mm) | Notes |
|---|---|---|---|
| Single DIN or Double DIN | 7"×2" or 7"×4" | 180×50 or 180×100 | Vehicle supports both radio sizes |
- Always measure the slot before purchasing a new radio
- Check slot depth - it may vary
Additional Notes
- The 2007 Audi RS4 uses 6.5 inch speakers in both front and rear door panels, which may allow for standardized component selection when upgrading the factory audio system.
- Door panel locations in this vehicle can accommodate either midbass drivers or full-range speakers, potentially offering flexibility in system design depending on whether separate tweeters are incorporated.
- Midbass speakers typically focus on midrange and lower frequencies when used with dedicated high-frequency drivers, while full-range speakers attempt to reproduce the entire audible spectrum from a single cone assembly.
- Replacing factory speakers with aftermarket midbass components could enhance vocal clarity and mid-frequency detail, particularly when paired with separate tweeters in a component speaker configuration.
- Full-range aftermarket speakers might provide a simpler installation path for the 2007 Audi RS4 since they don't require additional tweeter mounting locations or crossover network modifications.
- The identical sizing between front and rear positions suggests that the same speaker model could be installed in all four door locations if consistent tonal characteristics are desired throughout the cabin.
- Aftermarket speakers with higher sensitivity ratings than factory units could produce greater output levels with the same amplifier power, potentially improving perceived volume and dynamic range.
- Component speaker systems with separate woofers and tweeters often provide better stereo imaging than full-range speakers because high-frequency drivers can be positioned at ear level rather than in door panels.