1967 Chevrolet Malibu Speaker Sizes
The 1967 Chevrolet Malibu speaker size chart displays factory speaker locations and specifications for replacement or upgrade purposes. Information covers the center dash and rear deck lid positions within the audio system. Data assists with identifying compatible aftermarket speakers based on original factory specifications and available installation locations.
As an Amazon Associate, we may earn a commission from purchases made through links marked. Read more in our disclaimer.
| Location | Size | Type | Notes |
|---|---|---|---|
| Center Dash | 4x10 | Full-Range |
|
| Rear Deck Lid | 6x9 | Full-Range |
|
1967 Chevrolet Malibu Speaker Replacement Summary
2
total positions
1
easy to replace
0
high priority
0
professional only
Replacement difficulty:
Low: 1 Medium: 1 High: 0Replacement priority:
High: 0 Medium: 2 Low: 0Additional Notes
- The 1967 Chevrolet Malibu appears to have two speaker locations listed in its specifications, which may suggest that the rear deck lid position could take priority as a replacement candidate, given that the 6x9 inch opening generally accommodates a wider range of driver sizes and tends to support greater low-frequency output than smaller formats.
- The center dash location is listed at 4x10 inches, a somewhat elongated format that may limit compatibility to full-range drivers specifically designed for that form factor, which could narrow the available selection compared to more common round or standard oval sizes.
- Both locations are noted as compatible with full-range speaker types only, which may indicate that component or coaxial configurations with separate tweeters could face fitment constraints in these positions.
- A full-range driver in the rear deck lid position, operating at 6x9 inches, may tend to produce a more balanced frequency response across mids and highs relative to the smaller 4x10 inch center dash unit, though the actual outcome would also depend on the individual driver specifications.
- The use of full-range speakers across both positions may suggest that the factory design was intended to distribute sound from a single amplifier channel without crossover networks, which could be a relevant consideration when selecting replacement drivers.