2017 Chevrolet Tahoe Speaker Sizes
A speaker size chart for the 2017 Chevrolet Tahoe details factory specifications and locations throughout the audio system. Information covers replacement and upgrade options for aftermarket speakers in the front door panel, rear door panel, dashboard, center dash, and d-pillar positions. Data includes specifications for each factory speaker location.
As an Amazon Associate, we may earn a commission from purchases made through links marked. Read more in our disclaimer.
| Location | Size | Type | Notes |
|---|---|---|---|
| Center Dash | 3.5 | Full-Range |
|
| D-Pillar | 2.5 | Midrange |
|
| Dashboard | 2.5 | Midrange |
|
| Front Door Panel | 6x9 | Full-Range |
|
| Rear Door Panel | 6.5 | Midbass / Full-Range |
|
2017 Chevrolet Tahoe Speaker Replacement Summary
5
total positions
2
easy to replace
1
high priority
1
professional only
Replacement difficulty:
Low: 2 Medium: 2 High: 1Replacement priority:
High: 1 Medium: 3 Low: 1Additional Notes
- The D-Pillar and Dashboard locations in the 2017 Chevrolet Tahoe both share a 2.5 inch midrange configuration, which suggests these positions may be intended primarily for upper-frequency reproduction rather than handling the full audio spectrum.
- The Rear Door Panel's 6.5 inch size tends to allow for midbass or full-range driver compatibility, which could make it a relatively higher-priority replacement location for those seeking improved low-mid frequency output.
- The Front Door Panel's 6x9 inch size is among the larger positions in the vehicle, and its full-range compatibility may indicate it carries a broader portion of the audio workload across the front soundstage.
- The Center Dash position holds a 3.5 inch full-range driver, which is somewhat larger than the 2.5 inch midrange positions and could suggest a slightly wider frequency response at that central location.
- The combination of a 6x9 inch front and a 6.5 inch rear door placement may indicate that door panel locations are likely where the most noticeable sound quality changes would occur if replacements were made, given their larger cone surface areas relative to the smaller positions.