1979 Toyota Land Cruiser Speaker Sizes
The 1979 Toyota Land Cruiser factory audio system locations include front door panels and rear door panels, where front door panels and rear door panels accommodate 5.25 inch speakers. Available compatible speaker types for a speaker size upgrade and replacement encompass midbass and full-range units.
Specific details regarding locations, speaker sizes, and types are outlined in the compatibility chart.
| Location | Size | Type | Notes |
|---|---|---|---|
| Front Door Panel | 5.25 | Midbass / Full-Range |
|
| Rear Door Panel | 5.25 | Midbass / Full-Range |
|
1979 Toyota Land Cruiser Speaker Replacement Summary
2
total positions
2
easy to replace
1
high priority
0
professional only
Replacement difficulty:
Low: 2 Medium: 0 High: 0Replacement priority:
High: 1 Medium: 1 Low: 01979 Toyota Land Cruiser Radio Slot Size (DIN)
| DIN Type | Size (inch) | Size (mm) | Notes |
|---|---|---|---|
| Single DIN | 7"×2" | 180×50 | Standard size for basic car radios with small display or no display |
- Always measure the slot before purchasing a new radio
- Check slot depth - it may vary
Additional Notes
- The 1979 Toyota Land Cruiser includes speaker locations in both front and rear door panels, with each position accommodating 5.25 inch drivers that can accept either midbass or full-range speaker types.
- Replacement speakers for the door panel positions would likely prioritize full-range types to handle a broader frequency spectrum, though midbass options could serve listeners focused on lower frequency reinforcement.
- The single DIN radio specification suggests the head unit opening follows standardized dimensions of approximately 180mm width by 50mm height, which may limit certain aftermarket receiver installations.
- Full-range speakers in the 5.25 inch size category typically incorporate smaller tweeters or whizzer cones to extend high-frequency response beyond what dedicated midbass drivers can produce.
- The identical speaker size across front and rear door panels in the 1979 Toyota Land Cruiser could simplify component matching when upgrading the audio system with aftermarket drivers.
- Sound improvement from aftermarket speakers would depend on factors including cone material, voice coil construction, and magnet strength compared to factory-installed components.
- Midbass speakers tend to emphasize frequencies between roughly 80Hz and 500Hz, while full-range designs attempt coverage from similar lower limits up to 15kHz or higher.
- The door panel mounting depth and available clearance would need verification before installing replacement speakers, as aftermarket models may have different mounting depths than original equipment.