1996 Ford Bronco Speaker Sizes
The 1996 Ford Bronco factory audio system features specific locations for audio components. Front door panels accept 6.5 inch speakers, and rear door panels accommodate 6x8 inch units. Selecting midbass and full-range driver variants enables a successful replacement upgrade.
Specific details regarding locations, speaker sizes, and types are outlined in the compatibility chart.
| Location | Size | Type | Notes |
|---|---|---|---|
| Front Door Panel | 6.5 | Midbass / Full-Range |
|
| Rear Door Panel | 6x8 | Full-Range |
|
1996 Ford Bronco Speaker Replacement Summary
2
total positions
2
easy to replace
1
high priority
0
professional only
Replacement difficulty:
Low: 2 Medium: 0 High: 0Replacement priority:
High: 1 Medium: 1 Low: 01996 Ford Bronco Radio Slot Size (DIN)
| DIN Type | Size (inch) | Size (mm) | Notes |
|---|---|---|---|
| Single DIN | 7"×2" | 180×50 | Standard size for basic car radios with small display or no display |
- Always measure the slot before purchasing a new radio
- Check slot depth - it may vary
Additional Notes
- The front door panels in the 1996 Ford Bronco accommodate 6.5 inch speakers, which can function as either midbass drivers or full-range units depending on the audio system configuration. Midbass speakers typically handle frequencies from approximately 80Hz to 500Hz, while full-range speakers cover a broader spectrum without requiring separate tweeters or subwoofers.
- Rear door panel locations accept 6x8 inch oval speakers designated for full-range operation. The oval footprint provides additional cone surface area compared to round 6.5 inch speakers, potentially offering greater output in the midrange frequencies where vocal and instrumental content is concentrated.
- Replacing factory speakers with aftermarket components may address common sound quality limitations found in OEM audio systems, such as reduced dynamic range, limited frequency extension, and lower power handling capabilities. The dual speaker location configuration allows for staged upgrades based on listening priorities.
- The single DIN radio opening in the 1996 Ford Bronco dashboard measures approximately 2 inches in height and 7 inches in width, following the standardized DIN 75490 specification established in the automotive industry. This opening size determines compatibility with replacement head units and influences the total system power available to drive upgraded speakers.
- Full-range speakers designated for the rear positions typically incorporate a whizzer cone or coaxial tweeter design to extend high-frequency response beyond what a standard woofer cone can reproduce. This design approach differs from component systems that use separate crossover networks and dedicated tweeters.