2010 Mercedes-Benz E350 Speaker Sizes
The 2010 Mercedes-Benz E350 speaker size chart provides factory specifications and locations for audio system components. Information covers replacement speakers in front door panels, rear door panels, rear side panels, and rear deck lid positions. Aftermarket upgrade options reference original equipment sizes for each installation location within the vehicle audio system.
As an Amazon Associate, we may earn a commission from purchases made through links marked. Read more in our disclaimer.
| Location | Size | Type | Notes |
|---|---|---|---|
| Front Door Panel | 1 | Tweeter |
|
| Front Door Panel | 6.5 | Midbass / Full-Range |
|
| Rear Deck Lid | 2.75 | Midrange |
|
| Rear Door Panel | 6.5 | Midbass / Full-Range |
|
| Rear Side Panel | 1 | Tweeter |
|
2010 Mercedes-Benz E350 Speaker Replacement Summary
5
total positions
4
easy to replace
2
high priority
0
professional only
Replacement difficulty:
Low: 4 Medium: 1 High: 0Replacement priority:
High: 2 Medium: 2 Low: 12010 Mercedes-Benz E350 Radio Slot Size (DIN)
| DIN Type | Size (inch) | Size (mm) | Notes |
|---|---|---|---|
| Single DIN or Double DIN | 7"×2" or 7"×4" | 180×50 or 180×100 | Vehicle supports both radio sizes |
- Always measure the slot before purchasing a new radio
- Check slot depth - it may vary
Additional Notes
- The 2010 Mercedes-Benz E350 factory audio system contains multiple speakers across different locations, with tweeters positioned in both front and rear areas to handle high-frequency reproduction.
- The door panels house the largest speakers at 6.5 inches, which can accommodate either midbass drivers or full-range units depending on the system configuration and upgrade preferences.
- A midrange speaker in the rear deck lid location may handle frequencies between the tweeter range and the lower frequencies produced by the door-mounted speakers.
- Replacing the door panel speakers could potentially yield the most noticeable improvement in overall sound quality, as these locations typically reproduce the majority of audible frequencies in most automotive audio systems.
- The presence of dedicated tweeters in four locations suggests the factory system or aftermarket upgrades may use component speaker designs rather than relying solely on full-range drivers.
- Component speaker systems that include separate tweeters and midbass drivers might take advantage of the existing tweeter locations while upgrading the 6.5-inch positions with higher-quality midbass units.
- The 2.75-inch midrange location presents a less common speaker size that may require specific aftermarket solutions or adapters if replacement becomes necessary.
- Full-range speakers installed in the door positions would need to handle the entire frequency spectrum without assistance from the tweeters, though this configuration might simplify the replacement process.